Westerbeke 16.0KW SBEGA-50HZ Specifications Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
FUEL
SYSTEM
GASOLINE
Use unleaded 89 octane or higher gasoline. When fueling,
follow
U.S. Coast Guard regulations, close off all hatches and
companionways
to
prevent fumes from entering the boat, and
ventilate after fueling.
NOTE:
The
generator compartment should
have
a gasoline fume
detectorlalarm properly installed
and
working.
GASOLINElWATER
SEPARATOR
AND
FILTER
A primary fuel filter
of
the water separating type must be
installed between the fuel tank and the engine
to
remove
water and other contantinan!'s from the fuel before they can
be carried to the fuel system on the engine.
These gasoline filters must have
metal bowls (not "see-
through")
to meet U.S. Coast Guard requirements. The metal
bowls have drain valves to use when checking for water and
impurities.
FUEL
PUMP
Periodically check the fuel connections
to
and out
of
the
pump and make sure that no leakage is present and that the
fittings are tight and secure. The engine mounted fuel pump is
maintenance
free.
.
ENGINE
FUEL
FILTER
Periodically check the fuel connections and the filter bowl for
leakage. Replace the filter element after the first 50 hours. See
the MAINTENANCE SCHEDULE.
OWNER
INSTAUED
FUEL
WATER
SEPERATOR
(WESTERBEKE
PART
'49602)
ELEMENT
D·RING
Changing
Filter
Element
1.
Shut off the fuel supply.
2. Ensure there is no pressure in the fuel system
by
bleeding
off any existing pressure using a Schrader valve on the
throttle body and the fuel cell.
Use a pressure testing kit as
shown below.
3. Unscrew the fuel bowl from the housing and allow the
bowl to come away from the housing.
4.
Remove and replace the filter element and clean the bowl.
5. Inspect both O-rings. Replace if necessary.
6. Press on a new filter and replace the filter bowl.
7.
Open the fuel supply. Inspect for leaks.
INLET
FUEL
FILTER
1.
Shut off the fuel supply to the generator. Disconnect the
fuel supply line to the inlet filter and unscrew the filter
from the pump inlet. Take care to catch any fuel that may
be present.
2. Thread on the replacement inlet filter and connect the fuel
supply line.
Use care when connecting and tightening the
fuel supply line so as not to distort the inlet filter.
3, Tum on the fuel supply to the generator and start the
generator. Ensure that there are no leaks.
A
WARNING:
Shut
off
the
fuel
valve
at
the
tank
when
serviCing
the
fuel
system.
Take
care
In
catching
any
fuel
that
may
spill.
TO
FUEL
INJECTOR
SCHRADER
TEST
PORT
FUEL
CELL
(FUEL
PUMP/FILTER)
ENGINE
FUEL
FILTER
FUEL
PUMP
Engines & Generators
15
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Comments to this Manuals

No comments